Bloke Fly rod blank XL50 9′ 8wt 4-piece…FULL KIT! for first time build.
Building your first fly rod with the Bloke Fly Rod Blank XL50 9′ 8wt 4-piece kit is an exciting project! Here’s a step-by-step guide to help you through the process, along with tips for a successful build.
—
1. Unpack and Inspect Your Kit
Ensure your Bloke XL50 kit includes:
– Rod blank (4-piece, 9′ 8wt)
– Guides (single-foot or double-foot, likely 9–10 guides + tip-top)
– Reel seat
– Cork or EVA grip
– Winding check, hook keeper (if included)
– Thread (color-matched or neutral)
– Epoxy (for glue-up and finish)
– Optional: Decorative thread, alignment dots, or decals.
—
2. Tools You’ll Need
– Rod wrapping stand (or DIY with books/V-blocks)
– Thread tensioner (a book or coffee cup works)
– Scissors/razor blade
– Lighter or thread burner (to melt thread ends)
– Masking tape
– Rubbing alcohol (to clean surfaces)
– Cork reamer (if fitting the grip)
– Epoxy mixing tools (popsicle sticks, small cups).
—
3. Step-by-Step Build Process
A. Dry-Fit Components
1. Test-fit the reel seat and grip on the blank’s butt section.
– Sand the blank lightly if needed for a snug fit (use alcohol to clean afterward).
– Tip: Use a small amount of masking tape to mark positions before gluing.
2. Align the guides by flexing the rod to determine spacing (search “fly rod guide spacing chart for 9′ 8wt” for a starting point).
– Mark positions with masking tape.
B. Glue the Reel Seat & Grip
1. Mix 24-hour epoxy (slow cure = more working time).
2. Apply epoxy to the blank where the grip and reel seat will sit.
3. Slide components into place, rotating to spread epoxy evenly.
4. Wipe off excess and let cure (follow epoxy instructions).
C. Install the Guides
1. Start with the stripping guide (largest guide, closest to the grip).
– Wrap thread tightly around the foot, overlapping by 1/3 of the thread width.
– Secure the end with a drop of glue or burnish with a toothpick.
2. Repeat for all guides, working toward the tip.
– Tip: Use a “half-hitch” knot to finish each wrap before clipping excess thread.
3. Tip-top guide: Apply a tiny drop of epoxy to the blank tip before sliding it on.
D. Apply Thread Finish
1. Mix rod finish epoxy (e.g., Flex Coat) and apply thinly over thread wraps.
– Rotate the rod slowly for 10–15 minutes to prevent drips.
– Let cure for 24+ hours.
E. Final Touches
1. Add a hook keeper (if included) near the grip.
2. Inspect for rough spots or epoxy bumps (sand lightly if needed).
—
4. Pro Tips for First-Timers
– Go slow: Rushing epoxy or wraps leads to mistakes.
– Watch alignment: Ensure guides follow the rod’s spine (flex the blank to find it).
– Less epoxy = better: Too much looks messy and adds weight.
– Practice wraps: Use scrap material to test thread tension.
—
5. Resources
– YouTube: Search “fly rod building tutorial” for visual guidance.
– Forums: Check [RodBuilding.org](https://www.rodbuilding.org/) for advice.
—
Your Bloke XL50 will be a killer 8wt for bass, pike, or saltwater! Post pics of your build—we’d love to see it. Tight lines! 🎣